Recent content by xRowdyxBurnsx

Ok, think I am just going to go back and tap the front and see what happens. I would like to keep the 2 channel amp on the tweeters but if the front does not have 3k hz or so plus, I guess I will just remove the amp and then replace the tweeters. Thanks for the help!

@iexiak Curious, I was under the assumption that the fronts were not full range because the tweeters are separate. Anyone know for sure? I will just re-wire and tap the fronts to get the phone back based on his thoughts. Guessing if @markboris has not done an interface, is using CarPlay, that...

@iexiak Thanks for taking the time to do that for me. Sounds like if I reconnect the tweeters to ACM I can get some back. I found a good set of high efficiency tweeters that can be crossed over at 2k hz to replace factory tweeters and probably will be just as good as the 35RMS I am sending...

So I finally have my aftermarket budget install completed! Sounds amazing on stock interior speakers too. One MAJOR issue which I will get to and hopefully get an answer. First though, materials: 4 GA OFC Wiring Kit $60 3-way Fused Distribution Block $20 3-way Ground Distribution Block $15 RCA...

Got it. Saved me the heart ache of trying to tap into the tweeters for high level then. Back to original plan. I will have everything running off my DSP so will have to tune it all accordingly. I may just tune everything to lower volume to reduce roll off but I will cross that bridge when I get...

Thanks for your input! So I have found contradicting information about the signal going to the tweeters: 1. One owner reported they are actually full range but I can't find anything to actually confirm. They tapped the tweeters for high level inputs. However, the signal still contained roll...

So yes and no with the DSP. Kinda goes like so. (1) When I tap into the say rear speakers coming out of stock DSP, (2) input into my aftermarket DSP with those as a high level, (3) use my parametric input EQ to attack the roll off pending what Q factor/frequency I use, then adjust my DSP EQ, and...

Appreciate it! This was already a big help. So I read some older threads, and am also wondering which channels I should use for my high level input (DSP has inputs), front, rear, or tweeter channels. Currently I was planning on using the rear to the PAC harness AD-FD2. decided I am not going...

Oh, I am going to replace them. Just installing the multiple amps before I do and wanted to get that part out of the way. I am actually replacing all of the speakers but like to know what I am getting into instead of going in blind.

Hello friends. Was wondering if anyone has experience on running wires from an amp to tap into the stock B&O system. I am having issues figuring out how to do so. I understand the ACM is behind the media display but from what I can tell it seems the tweeter connection is FACRA. I don't want to...

So happy I found this thread. So much good information!!! I have a ‘23 with B&O I am about to start working on. Don’t quite have the cashflow for an absolutely stunning build like this but will work with what I have. I read somewhere that the stock electrical can only handle about 1000 RMS...

Just want to thank you for this thread and the other info you have provided. I am in the process of planning my build. I took a 25 year break from car audio until my last vehicle, an Infiniti Q50, which I just traded in for an 8k ‘23 GT. This system has me quite confused and would appreciate...