Search results

Alas, no. Despite the totality of the Ford organization searching diligently for the needed parts, they remain unavailable. I have nothing positive to report but the flak catchers are exceedingly polite.

Lemon laws are not applicable. It is under warranty but it's too old and has too many miles.

Just for follow-up, it is now one month that my MME is at the dealer due to a failed update. I am told that the electronic parking brake actuators need to be replaced but they are not available and there is no timetable for when they might be. I am now the proud owner of a 2 ton paperweight...

I've been communicating with a customer service person. I emailed him earlier to ask to get a repurchase going. Should I go higher up? Any formulas to calculate what a repurchase amount should be? Thanks.

Three weeks ago, I took my 2021 MME AWD to the dealer for its 30k service. They performed the 22P31 CSP and as a result, the parking brakes locked up. To try to remedy that, other things were done but without success. Now I'm told that they need to replace some parking brake part on each wheel...

I have to admit that I am a rule follower. If Ford says that for long-term storage, the HV battery should be at 50% and the 12v battery disconnected, that is what I plan to do. Coincidentally, my car is at the dealer now for its routine 30K service. I had received a few error messages about a...

Can I ask - did you try to charge the 12v battery prior to towing to the dealer and do you know if the 12v is an AGM battery? Thanks.

How does leaving the hood open prevent mice from finding a nice spot to nest? I think that my mice are more industrious than yours. Do I need any tools to remove the trim panels?

Two questions as I will be storing my MME for 6 months. 1. How do I access the 12v battery? 2. In the past on ICE vehicles, I've disconnected the 12v battery and not used a maintainer. After 6 months and reconnection, the car started. I would like to follow the MME manual and disconnect the...

I apologize in advance as I did not read the entire post, but I just drove from the Florida Keys up to the Baltimore area. I have a red Mach-E and charged in Florence on Saturday, 4/16. If you're on I-95 and looking for a good place to stop, I highly recommend EA in Pooler, GA. It charges by the...

Can you get spiedies nearby?

Some of us Harpur grads don't know what a Binghamton University is.

I had the same problem and it was cured by a master reset. I did then setup anew my profile, but I would like to duplicate my profile for my wife, hence my other topic in this forum. It would be a good feature to be able to save and reinstall a profile after a master reset.

I have set up my personal profile and would like to set one up for my wife, but before i go through all the steps again, I was wondering if there is a way to simply make a 2nd profile with all the same selections but with a different name?

Please forgive me if this was already mentioned but I did not read through 12 pages of comments. My Fordpass notification says that a power-up software update will be available later this year OR if you're impatient, you can get it done sooner at the dealer. MY PAAK is not perfect but it's not...

Is there any way to change address that the Ford Pass app assigns to a charger? I live far off the road where my address is located so a street that is closer to my house shows up for my address. Also, is there a method to preemptively set all DCFCs to charge to 80%? I only use them if traveling...

I've used P & C 6 times now driving from FL to MD along I-95 and it has worked fine. My main issue is with the condition of the restrooms in Walmart. They need to clean them more frequently.

Thanks to all. We'll take a cooler, use the frunk for not-temperature-critical items.

Thanks for the advice. I have a Bolt and have set up accounts at all of the charging networks but unfortunately, all of the ID cards are in the Bolt's glove compartment in another state. I did plan out my FL-MD route and all the stops will be EA.

I'm taking a long road trip soon and was wondering about the insulation qualities of the frunk. How long should a load of ice last? How frequently should I add more? Should I just take a regular cooler?