Search results

  1. murphy62

    Modification to prevent loss of the clips that hold the three panels in the "frunk".

    This procedure will block the open end of the structure that allows the clip to slide out. Get some small diameter steel wire or failing that a supply of paper clips which are usually made from steel wire. Select a drill bit that has a diameter slightly larger than the wire. Look at the open...
  2. murphy62

    Check Your Lug Nut Torque

    I forgot to check the lug nut torque after I had put 100 miles on the Mach-E. I remembered it after 300 miles. The recommended lug nut torque specification is 150 lb-ft. All of mine were loose between 1/3 and 1/2 turn. That is the highest torque I have seen on a car. My 2013 Fusion Energi was...
  3. murphy62

    SYNC Editing Failure

    I was sitting in my Mach-E, in the garage, going through all of the menus. I found one with a Fuel label. I tapped it and got a picture of a gasoline pump and the locations of the gas stations within a few miles of my house. An example of "cut and paste" without paying any attention to what...
  4. murphy62

    Reverse Collision Detection

    I had to turn reverse collision detection off. My driveway slopes down to the street. The car consistently detected the approaching street as a collision object and slammed on the brakes. That made it difficult to get out of my driveway. A large box appeared on the dash to tell me that the...
  5. murphy62

    Time Line of my Order

    2021 Mustang Mach-E Premium AWD ER Order 1/06/21 Dealer Approved 1/07/21 Build Week 5/24/21 Build Day 5/31/21 Ship on Kansas City Southern 6/01/21 Arrive in Kansas City 6/15/21 Truck to Norfolk Southern 6/15/21 Delivery in Jenkintown, PA 6/28/21 The first ETA...


Top