Charge Port Cover Dent Prevention – 3D Printed DIY Solution

[AEtherScythe]

hats off to whomever came up with this and set up the jawstek ordering. Quite remarkable

Glad you like! Enjoy!

Sponsored

 

[motown moproblems]

Glad you like! Enjoy!

Just had my MY22 charge port door replaced because the little plastic release tab for the body piece broke off. They had to replace the entire housing. It looks like the latest part revision is different than original and my 3d-printed piece I ordered from jawstec no longer will fit. There is now a small plastic divider down the middle of the formerly open space where the piece slotted in. Any ideas/potential for a redesigned part? I may attack it with a box cutter and see if I can rig it myself, but I'm also curious if this is a change present on MY23 vehicles onward. New hinge overhead view photo below (part LJ8Z*10370*B).