cmtaylor963
Well-Known Member
- First Name
- Charles
- Joined
- Jun 19, 2020
- Threads
- 4
- Messages
- 239
- Reaction score
- 346
- Location
- Springfield, MO
- Vehicles
- Mach E 1st Ed
- Occupation
- Engineer
Settings>Vehicle>Backup Start PasscodeOkay I can't for the life of me figure out how to set up the backup start pass code. I found the instructions in the manual to set the five digit door code to get into the vehicle, and that works. But once I am in the vehicle I cannot get the screen to show a passcode. I went into the manual and it explains how to use a backup start passcode but I have no idea where to set up such a code. I read in this thread that it's supposed to be eight digits but I only have the five digit master code they gave me for the door. How do you actually get into the car and start driving and using only a passcode and not a phone or fob? Where is this elusive 8 digit passcode for the screen?
If you're in the vehicle with no PaaK or fob, you have to press the start button a few times with the No Key warning message (2 or 3 times) before the passcode option pops up on the display. There may be a time delay too, but I'm too impatient, so I just smash the start button until it shows up haha.
Sponsored