i know the sensor is behind the bumper but that circle on the bumper below is also covered up. I tried to feel for it through the wrap but I don't feel anything in the area. Could that area affect it as well? Or they just set the sensor inside the bumper incorrectly?It may have been set incorrectly. Check the angle of the setting.
Alright. Appreciate your knowledge ?This is a parking sensor. You can check if it shows obstacles when parking.
There is a blind spot radar (BLIS) under the bumper that must be set at a good angle. If it gives you an error while driving, then the problem is with the radar.
Unfortunately, the radar is under the bumper and its setting requires some knowledge.
No it wasn't hit. Its a 25, and I started the wrap the same week but it didn't give me thus error until after the wrap.It is best to connect a tester and check what error is recorded.
The photo shows the rear left radar in the holder.
The car was not hit? I ask because after a collision it happens that the radar is set incorrectly.
![]()
Oh im not that skilled ?Great. I was also thinking about changing the colorAre you going to do the wrapping yourself?
I watched the training materials and it doesn't look difficult, but it does require experience and patience
If you have any questions or need advice, you can write me a private message![]()