Passenger window auto-up inoperative

[pswired]

Anyone else with this issue? The passenger side front window will raise and lower normally if the switch is held up/down, but the auto-up feature (pull up on the switch once) does not work. The feature works for the other windows. Used to work. 17k miles. I assume something is binding up and triggering the resistance sensor?

Sponsored

 

[Neil4Real]

Calibration procedure, courtesy of @Mach-Lee (and many others, I'm sure, but I stole this from his post on it):

1. Start the engine.
2. Press and hold the window control switch until the door window is fully open.
3. Release the window control switch.
4. Lift and hold the window control switch until the door window is fully closed.
5. Release the window control switch.
6. Lift and hold the window control switch again for at least one second.
7. Press and hold the window control switch until the door window is fully open.
8. Release the window control switch.
9. Lift and hold the window control switch until the window is fully closed.
10. Test for correct window operation by carrying out the one-touch down and one-touch up features.

If this doesn't work, then a dealer visit it is!

 

[pswired]

Thank you thank you! I bet that will do the trick. Very glad to not have the dealer tearing into my door.

 

[dougni]

Happened to me before, but the driver window. I did the calibration procedure that is in the manual and it worked.

 

[MarkP213]

Anyone else with this issue? The passenger side front window will raise and lower normally if the switch is held up/down, but the auto-up feature (pull up on the switch once) does not work. The feature works for the other windows. Used to work. 17k miles. I assume something is binding up and triggering the resistance sensor?

Just happened to me yesterday with the driver’s window!

Sponsored