Installed the AOSK Rear Bumper PPF

[Mr. Toejam]

https://www.amazon.com/dp/B0B2RQH7QR?psc=1&ref=ppx_yo2ov_dt_b_product_details

I bought this as I needed to protect my bumper from my dogs jumping in and out.

I do wish this was textured like the Ford version one and I wish it was a little thicker.

https://accessories.ford.com/products/mustang-mach-e-2021-rear-bumper-protector-1

But at a 1/3 of the price, not textured and a little thinner is not an issue. If you have done any PPF install, it was a piece of cake. A little Slip solution to put it in place and then spray some tack solution and squeegee it out. Done in about 4-5 minutes. It will do it's Job, but I did notice 2 things.

1) The cut is really not that clean. The radius from the wide section to the narrow section does not follow the bumper shape.

2) I wish it went from the end of the bumper all the way to the bottom of the weather stopping. It ends up over an inch short of reaching the stripping and that means a fairly large area where the bumper is exposed.

 

[bs1055]

Good to know! Thanks for sharing. We have a stroller that we roll in and out of the trunk 3x (minimum) times a day and inevitably bump that area.