Front license plate WITHOUT drilling holes in bumper

[intensifi]

From Sto and Sho out of Morgan Hill, CA.

They make them for GT and non GT models.

A little pricey but we have license plate readers here for the express lanes. My net cost is the frame minus the cost of the express lane transponder which I did not have to purchase.

Sponsored

 

[Larry Paul]

Very interesting. I found them at:

https://stonsho.com/

 

[Ghost Ryder]

you're in california. You could of gotten the vinyl license stickers.

 

[Larry Paul]

you're in california. You could of gotten the vinyl license stickers.

yes…But then they are stuck on the bumper and always there.

 

[Ghost Ryder]

yes…But then they are stuck on the bumper and always there.

not if put it on top of a paint protection film. I do that for the carpool sticker, works like a charm.

 

[intensifi]

you're in california. You could of gotten the vinyl license stickers.

Truth!

But it would have to be cut down to fit the available bumper area on an GT. Also Ford included two raised bumps to show you where to drill.

With all that and the sample Vinyl sticker shown on a GT on the approved vendor’s website, we decided this looks much better and is completely removable when we want to.

 

[Ghost Ryder]

Truth!

But it would have to be cut down to fit the available bumper area on an GT. Also Ford included two raised bumps to show you where to drill.

With all that and the sample Vinyl sticker shown on a GT on the approved vendor’s website, we decided this looks much better and is completely removable when we want to.

True. Or roll the dice and go commando.

 

[Larry Paul]

not if put it on top of a paint protection film. I do that for the carpool sticker, works like a charm.

You can remove it and re-install it at will- or it has to be applied… and if you remove it- you can’t reinstall it?

 

[HuntingPudel]

I didn’t cut my license plate wrap. I just bent it in the right places and used a heat gun to keep it smooth. ?‍?

 

[intensifi]

I didn’t cut my license plate wrap. I just bent it in the right places and used a heat gun to keep it smooth. ?‍?

Understand but on a GT the look wasn’t working for us.

 

[HuntingPudel]

Understand but on a GT the look wasn’t working for us.

The black plate has better dimensioning for the front bumper. Everyone also has their own level of where they think the aesthetics work for them. ?‍?

 

[mkhuffman]

I have been using the Sto-n-sho for 14 months now. I think it looks so much better than the vinyl plate, it is removable, and it doesn't get destroyed by rock dings.

You just have to pay special attention to curbs:

 

[AliRafiee]

From Sto and Sho out of Morgan Hill, CA.

They make them for GT and non GT models.

A little pricey but we have license plate readers here for the express lanes. My net cost is the frame minus the cost of the express lane transponder which I did not have to purchase.

Doesn’t that interfere with the radar?

 

[intensifi]

I have been using the Sto-n-sho for 14 months now. I think it looks so much better than the vinyl plate, it is removable, and it doesn't get destroyed by rock dings.

You just have to pay special attention to curbs:

That my friend is what the camera button in 4.1.2 is for!

 

[intensifi]

Doesn’t that interfere with the radar?

It worked fine in my test run.

Sponsored