Search results

I've taken the passenger side A-pillar off twice in the past and know it's tough to reinstall, but yesterday I spent at least forty-five minutes wrangling it. It refused to pop into place (and I did remove the black pieces and push onto the clips, so it wasn't that). I seem to remember the...

Perhaps @HuntingPudel wants to comment on his experience? ?

If it's the "main battery", it's most likely the HVBJB or else one of the battery modules (not the entire battery pack).

Agreed. I forget if there are some setting you need to enable, but I believe there are and if you don't have those showing up then you'd need to change them with FORScan. I know @rugedraw would know for sure. He helped me change mine.

So the car graphic on the Instrument Cluster shows arrows on either side? That would mean it at least has BC 1.3 updates, even if it's not functioning.

Yeah, I have 6g cables with lugs. Here's a earlier post detailing all the cables and clamps I bought.

Another power supply which has worked well is the one below. The voltage is adjustable, but also has a fixed 13.8V setting. It has a voltmeter/ammeter; the ammeter is useful when you want to see how much current the car is drawing during module programming. TekPower TP50SW 50 Amp Analog DC...

Check @dtbaker61's thread, specifically resetting the BCM.

In the past, @rugedraw was loaning out equipment (the Mongoose, at least) for a deposit.

.

Buy the OBDII dongle and download FORScan. The Vgate vLinker FD was one of the most valuable $30 I ever spent.

This. We've all read the horror stories of some dealerships. Ours (Big Valley Ford in Stockton) has been nothing short of stellar.

I concur. I miss it too.

I searched around and found some parts (P-channel MOSFET and voltage reference/comparator) that simulations indicate would do the job, and so I just ordered from mouser.com. Assuming it really works, the total cost would be a little under over $9 a board in quantities of 10 (including the...

Yes.

2021 Mustang Mach-E - Illuminated Powertrain Malfunction Indicator (Wrench) Lamp - Various Diagnostic Trouble Codes (DTC) - Built On Or Before 30-Sep-2021

This speaks volumes. Two years after Ford’s announcement, and sixteen months after the network opening up. ?

Good point, but I'm much more computer than electrical so that's my go-to. Plus, shiny Arduino! But I'll have to look at that more closely to see if it would work in my situation.

This seems to be one of the dashcam threads which gets lot of references, so I thought I'd add one more post about my experience. I bought a dashcam based on a kickstarter campaign (big mistake, but we move on) and purchased a 70mui A810 to replace it. However, the UP03 hardwire kit had a...