Jump Start cover

[agdad]

The small squarish cover for battery connecting on my front bumper will not stay in place.
Almost every time I drive it ends up hanging loose by the plastic cable in front and has to be secured back into the front bumper.
Anyone have a fix for this other than glueing it into place ?

Sponsored

 

[generaltso]

Have the dealer replace it.

By the way, those wires don’t jump start the car. They just pop the frunk when the 12V battery is dead.

 

[MyLittlePony2022]

I would also go back begrudgingly to the dealer to get it replaced via warranty. It should not be coming off.

FYI, to jump start your car, you have to get into the frunk and remove the right hand side of the plastic trim panels. The battery is on the right side of the car. Search the forum and you will find a few threads of how people drilled and put caps above the battery post to allow for easier access to jump start the car. This eliminates the need to remove the trim. I did it and love it.

 

[agdad]

Actually I knew it would not jump start the car but open the frunk.
I've cut ( 2 ) two inch round holes over my + and - battery terminals so that I can just pop then off to get to the battery terminals.
I got the 2 inch caps from ebay and marked them as + and -

Sponsored