rkmoray
Well-Known Member
- First Name
- Rick
- Joined
- Apr 9, 2023
- Threads
- 23
- Messages
- 110
- Reaction score
- 74
- Location
- Vaughan Ontario Canada
- Vehicles
- 2023 MME
- Occupation
- Software Development Manager
Does it effect the warranty?
Sponsored
Erik if it'll work for you in Arizona it'll work for me... pls do write here after you've installed it about how well this shield works with the pano roof in the heat of the Summer.The heat is there, it’s very hot about 1/2 inch from the glass. It probably doesn’t heat the car up as much as the cold leaches from the cabin though.
I can get temps this weekend. I’m not trying to solve heating the car up so much as keeping that layer of hot air from the top of my head.
As I understand it there is a foam tape that is holding this on, I’d figure enough air would get past that into the headliner to keep from heating up too much, plus it’s poly, so before cracking the glass I’d expect a big poly balloon on the interior.
once the car is moving the outside air does a great job of stripping the heat from the glass. But if stuck at a light for 4 minutes or (which happens to me 4 times in my pick up the kid drive) so in 115+ that glass is blazing. Takes about a minute of driving to strip the heat from it. I’m trying to just keep the roof area about the same temp. There’s a good possibility this will actually trap heat and make it worse.
there is a couple Tesla’s that are using it around here. Like I said, cheap and easy enough I’ll take the gamble to try it out.
The Magnuson-Moss Act provides some protection from a car manufacturer warranty dispute. Essentially it forces the manufacturer to prove that an aftermarket product was responsible for a problem. The EVglass has been around for a couple of years now and no problems reported to me.Does it effect the warranty?
I tested to 70C/158F for two hours with no issues. The materials and adhesives I use were selected to stand up to typical summer glass roof temperatures.The heat is there, it’s very hot about 1/2 inch from the glass. It probably doesn’t heat the car up as much as the cold leaches from the cabin though.
I can get temps this weekend. I’m not trying to solve heating the car up so much as keeping that layer of hot air from the top of my head.
As I understand it there is a foam tape that is holding this on, I’d figure enough air would get past that into the headliner to keep from heating up too much, plus it’s poly, so before cracking the glass I’d expect a big poly balloon on the interior.
once the car is moving the outside air does a great job of stripping the heat from the glass. But if stuck at a light for 4 minutes or (which happens to me 4 times in my pick up the kid drive) so in 115+ that glass is blazing. Takes about a minute of driving to strip the heat from it. I’m trying to just keep the roof area about the same temp. There’s a good possibility this will actually trap heat and make it worse.
there is a couple Tesla’s that are using it around here. Like I said, cheap and easy enough I’ll take the gamble to try it out.
….and from an engineering and physics perspective, you are absolutely spot on correct my friend!The interior glass feeling colder (which it absolutely does, as I learned last Winter and this Winter driving thru Wisconsin, Minnesota, Colorado, Maine etc.) chills the cabin air, which in turn creates convection currents up & down across the cabin which chill said cabin air even further. Those cold convection air currents might feel like a slight draft as they waft across our exposed skin areas.
it is not a draft thru the roof glass... it is a convection "draft" inside the cabin air which is started and then reinforced through the coldness of the large cold surface of the roof glass. A result of one of the several Boyle's Laws on gases, and all that.
That's my story and I'm stickin' to it...
Yes that back seat sure is enlightening on cold highway drives. I still am surprised the back wasn't equipped with heated seats.Ordered! Live in Vermont, so definitely fall into the target audience.
Timing of this forum thread couldn't have been better/made for an easy sell! My wife was bumped to the back seat for the first time last night so her friend could fully enjoy her first MME ride. It was an hour-long interstate drive with a 10 degree (F) exterior temperature. Let's just say that she wasn't shy in expressing how much she missed the additional warmth of the heated seats up front. Texted her the link to this forum thread this morning - got back an emphatic, "ONLY $170?? YES!! ?".
Hopeful this add-on makes her next experience relegated to the second row a little less chilly, and will give me an eager extra set of hands to help me with the install in a week or so!
It's a sample piece so you can see how the foam is attached and how the adhesive piece that connects to the glass works. it's not for installation or any purpose other than for you to see how it functions before you attempt install.So my EVInsulate panel came in and with it came a little bag with eight (8) er,... "side clips" I guess to hold the panel up along the headliner. However, it also came with one other thing which is a mystery... perhaps someone can help me.
It is a longish (overall small though) clear plastic rectangle with a strip of tape down the middle. The foam tape has a red protective covering on its opposite side.
QUESTION: what is this piece for? Is it meant for the center of the EVInsulate panel? Then why the clear plastic rectangle already glued onto the tape? Thanks in advance.
Oh wow haha... thank you. I thought I was stoooopider than my son usually accuses me of beingIt's a sample piece so you can see how the foam is attached and how the adhesive piece that connects to the glass works. it's not for installation or any purpose other than for you to see how it functions before you attempt install.
Happy to help. Any time!Oh wow haha... thank you. I thought I was stoooopider than my son usually accuses me of being![]()