Error Msg: Charging Error - Mustang Mach E

[Mach-Lee]

The recall is done but the car is still telling me to do the 10.2.0 update.. should I just ignore it?

Yes ignore, it shouldn't even be trying to do 10.2.0 anymore. BTW, could you send me your VIN via direct message so I can see what's going on with this?

Sponsored

 

[jgruchey]

Sent

 

[Mach-Lee]

You had the 25S65 recall installed only yesterday, so your car hasn't had time to talk to the OTA servers and fail the 10.2.0 OTA. That will happen in the next few days. Again, it is expected that the 10.2.0 OTA will fail since you already have newer software installed now. You can ignore it.

Your dealer correctly validated the 25S65 recall software installation, there is not a problem with it and there is no further action required at this time.

Your charging error code was P0D56:24. This could be caused by not fully inserting the J1772 plug. See this topic for more information: https://www.macheforum.com/site/thr...24-code-and-possible-12v-battery-drain.23525/

The dealer also reset the 12V BMS, so that was taken care of as well.

In summary, just verify you've plugged in fully, and everything else is fine.

 

[jgruchey]

Amazing! Thank you so much!

 

[jgruchey]

Update on this - the car charged fine at the dealership. It was in fact the charger itself!

 

[desiguy2447]

Just to add to this old thread my Mach-E started doing the samething. However the car keeps charging to the set percent. I thought it was the Grizzle charger as to write ups but then I used the Lucid car charger at a friends house and the car did the samething and kept charging after throwing the error. So to sum it up my car is throwing a false postive error with e Grizzle and the Lucid home charger but it charges without needing to unplug it.

I am scheduled for a dealer visit for the 20K service check which past due and 12V battery as it been past 3 years.

Sponsored