Interesting about GWM. I wonder if that just popped up today. I don't have my FDRS laptop with me so I can't check until I get home. I noticed that after I ran the HVAC update the intelligent range program became activated. I assume that was just coincidence.
How could you tell that intelligent range became active? I thought it was survey side and you can't trust what the EAP says on the website as @benk016 said they're not linked, so what shows on the site doesn't mean your car actually has it active yet.
That’s exactly why I assume it was a coincidence. It had yet to show as an active product until 5-10mins after updating HVAC. I didn’t think anything of it until I saw your range boost comment.
Hopefully this means Job 2 2021s are finally getting SYNC'd up hahaha with Job 1s?
I have a feeling Early Access Job2 cars will see this as an OTA soon. Followed by a Sync update shortly after that.
What issue were you getting? It was my first USB update and... I was a bit dumb. I read the instructions and then see it say "did it install" so I stupidly click yes before actually doing it LOL. So I did it again, the car takes forever to recognize the USB. It then told me it'll be done the next time I turn the car on or something. So I did a full shut down, door open and then turned it on. Nothing, waited about 15 minutes. I then just clicked yes it completed but then FDRS said it has trouble communicating with my car, I kept retrying and eventually just decided I wasted too much time on it and exited FDRS and yanked the USB. When I REMOVED the USB, then it said it was safe to remove and the update was successful LOL. I reopened FDRS and it cleared. All DTC's cleared and none came back.
I got the unrecognized device. Tried with two drives. Both 64GB, ExFAT. Didn’t like them.
I got the same thing last FDRS update I did. Force restart sync while you’re not doing any updates and see if that causes it to recognize the usb drive. Worked for me.
2 hours later, GWM updated with no issues using CAN unattended. Ultimately I spent about ten minutes compared to the 30 minutes fiddling with the USB.
I tried that and it didn't seem to help. I took the slow option today, just started it and walked away for a couple of hours. I'll play around with getting a USB to recognize before the next update comes out.
On 2022's I'm seeing the exact same GWM software version as available but not the PCM, SOBDM, ...
