Post here if you have an active FDRS account and are willing to look up info for others

[Robob]

Those are all the modules with a manual update currently pending in the system. If you still have warranty coverage you could try to go in and say you had a few OTA updates fail and maybe say your phone as a key and charging and hvac have been acting up.
That would prompt them into updating the modules related to that such as TCU, HVAC, and other modules hopefully to get you started on OTA updates again.
If no warranty, try to use the guides stickied at the top of this forum section to help get OTA to trigger such as leaving car on to charge up the 12v battery etc.

Sponsored

 

[Dhelmet78]

I do have an appt in 2 weeks to get a recall done, I guess I'll have them check it then. Thanks.

 

[Robob]

No problem, remember to just say you have had issues with the OTA, charging, HVAC, PAAK. Dont mention that you know the list of updates to increase your chances. Gotta let them do their investigating and conclude the update is the easiest thing to try first.
Good luck!

 

[Dhelmet78]

I actually think one of the items they need to do is an update for the charge port. Which should have been done as an OTA, from what I understand, but they've not been working.

 

[itshaysus]

Do you mean...by looking up your VIN it might force updates to download? No.

Here's your list of available updates though...and you do have both a GWM (gateway) and an APIM (Sync) in the list at the same time which usually means something's keeping your downloads from happening (like maybe a low 12V battery or something).

That would explain why my last update was march 12. How would I check what’s keeping it? I thought the 12V charged when charging the car

 

[dpratel]

Hi I recently (last Friday) updated all available SW updates in FDRS but didn't have an APIM to get to 6.14.0.
I had been getting ZERO OTA's on my vehicle (22GTPE) so assumed I needed to get caught up to start getting OTA's. Not sure if I still have an OTA problem or if it's just not "my time" for the 6.14.0 OTA.
Would someone be willing to look at my VIN to see if it's available now in FDRS and I just have terrible timing? I'd also love to know if I had any scheduled OTA's in PTS or any that have failed. Thanks in advance!

VIN: 3FMTK4SX8NMA24653

 

[Robob]

3FMTK4SX8NMA24653

Almost part of the Fully Updated Club. But this DSP just popped for me last week so its pretty recent.
Probably the same situation as my car. Our batch of VINs hasn't been approved for that update yet so we must wait until the FDRS gods let us have it.

 

[dpratel]

Almost part of the Fully Updated Club. But this DSP just popped for me last week so its pretty recent.
Probably the same situation as my car. Our batch of VINs hasn't been approved for that update yet so we must wait until the FDRS gods let us have it.

Thanks! Curious on the DSP update. I did install it but it doesn’t seem to write back to the database. Did yours and it no longer shows in FDRS?

 

[Robob]

That would explain why my last update was march 12. How would I check what’s keeping it? I thought the 12V charged when charging the car

It does charge the 12v battery but sometimes its borderline on the voltage required to do the updates. Also, the OTA also goes by state of health of the battery, so if it's below a certain point it won't try the inhibit updates.

 

[Robob]

Did yours and it no longer shows in FDRS?

Yes I ran mine and it dropped off. It was a quick update, didn't even hook up the power supply. Just ran it after a longer 30+ min drive.
If you plug into the car and try to run the update it should check the software version and then hopefully it updates the database on the 2nd try.

 

[Just Lurking]

Hi folks, can anyone with FDRS tell whether the CMR module has received new software this month, particularly in the last week or two? It's not clear to me how much detail you guys with FDRS actually see, but if anyone is willing to take the time, I'd be very curious to see the software history for the CMR module dating back to last Fall.

I'm one of the folks who received 6.13 in December and it broke lane keeping and BC. The fix is supposedly an update to the CMR module. Ford announced an OTA in late Feb which failed to everyone who received it, then a TSB to manually program the CMR in early March which also failed to the handful of people who tried it. Then Ford announced a new OTA for the CMR which is now not only failing but also giving a "vehicle needs service" error.

And finally, Ford announced a new / revised TSB a week ago which once again involves programming the CMR module. Hence my curiosity to know if they released new CMR software in the last couple of weeks which hopefully will finally fix the trainwreck of bad CMR updates over the last few months.

Thanks in advance!

 

[Reganm59]

3FMTK3SU6MMA27596

 

[rugedraw]

@rugedraw please can you check if there is/was ota update for my car ? thanks much

Remind me on 4/1 when I'm back from vacation. I didn't bring my laptop with me.

 

[Robob]

CMR update popped a month and a half or so ago for me. It was 1.5hr update, but I did have some weird codes that had to be cleared a few times after I did it, made some other modules angry.
Im away from my FDRS machine til the morning but I will check if yours shows it if no one else pulls it

 

[360alaska]

Can you please check 3FMTK1RM4MMA27493

Sponsored