EV_Pilot
Active Member
- First Name
- Scott
- Joined
- Apr 7, 2022
- Threads
- 2
- Messages
- 32
- Reaction score
- 118
- Location
- Kansas City Metro
- Vehicles
- 2022 MME Premium AWD, 17 Ridgeline, 13 Leaf(sold)
What you need is the hardware sensor module (and I think two sensors under the bumper cover but less clear about this). That module was in my car just not enabled.
I found the info here: https://www.macheforum.com/site/thr...ands-free-liftgate-back-to-2022-mach-e.16407/
And back in post #1,173, @connoisseurr posted the module was on his car and that we should have it too.
When you go to that DIY post you see a picture where he has dropped the whole black shroud attached to the rear bumper. You don't need to do that. There are two little access panels held on with three hex head screws. Take the left one off. Then you can get a camera up there to look. I simply held my phone up in the hole and took several pictures are at various angles and spotted it. Then quickly ordered a cable off of Amazon. I used the $35 vLinker USB cable that is posted on the Forscan web page as a recommended interface.
I found the info here: https://www.macheforum.com/site/thr...ands-free-liftgate-back-to-2022-mach-e.16407/
And back in post #1,173, @connoisseurr posted the module was on his car and that we should have it too.
When you go to that DIY post you see a picture where he has dropped the whole black shroud attached to the rear bumper. You don't need to do that. There are two little access panels held on with three hex head screws. Take the left one off. Then you can get a camera up there to look. I simply held my phone up in the hole and took several pictures are at various angles and spotted it. Then quickly ordered a cable off of Amazon. I used the $35 vLinker USB cable that is posted on the Forscan web page as a recommended interface.
Sponsored